Limp mode can be caused by several conditions, but the trans and throttle behavior will be similar. The SES lamp should be on, and there should be DTC's
DmaxMaverick Yesterday, 18:29The latest, and thanks for the reply. I went ahead and purchased $140.00 Hitachi MAF sensor. Cleared code, installed and drove it and no issue with
Napco4WD Yesterday, 15:52Thanks to Robyn and Jim. Got it done and is mounted in truck, truck is running, but with issues!
Napco4WD Yesterday, 15:37MAF (Mass Air Flow) sensor not properly installed? Unplugged? Broken wire?
A decent code reader should be able to read the MAF signal. That'll
2001 LB7 P0102 code
Thank you Maverick. You are correct I get no codes on my cheap reader, and when this happens I don't get a check engine light? I have a friend who is
Napco4WD Today, 05:36