High Idle Install - Tool for the pin?

[XTOCAK]

Is there a tool for connecting the pin to the 20 gauge wire or are there any "best method" used to do this? I could solder it but see where that could cause problems inserting it into the ECM. Perhaps there's a better mousetrap someone's found for connecting the pin to the wire. Thanks.

[chuntag95]

The dealer tech has a fancy set of crimpers that you might talk him into crimping the pin on your wire (take both and a few bucks). I soldered mine and did not have a problem. If you remove the blue cover, it makes the whole think easier to get the pin all the way in.

[XTOCAK]

Chris, your description brings up a question...I did a search to see how to get it to work with my remote start but can't find an answer in easy laymans term. Do you any simple and stupid description for getting it to work with the remote start? Thanks.