letsgo
06-13-2003, 08:21
There have been a number of oil analysis posted which look quite impressive however I do not have any idea as to what the bench mark result should look like, for example copper cu. I think would be best if it were ZERO but I imagine not a realistic number.
I may be asking a lot, but would you be able to post an complete analysis report with a commentary on each item, covering the minimum and maximum and where this product is comming from eg. block, bearings, pistons, anti freeze, fuel.
Or if there is a site you can direct me to that would also be great, so long as its simple.
would appreciate any input.
thanks and good luck.
[ 06-13-2003, 02:54 PM: Message edited by: letsgo ]
I may be asking a lot, but would you be able to post an complete analysis report with a commentary on each item, covering the minimum and maximum and where this product is comming from eg. block, bearings, pistons, anti freeze, fuel.
Or if there is a site you can direct me to that would also be great, so long as its simple.
would appreciate any input.
thanks and good luck.
[ 06-13-2003, 02:54 PM: Message edited by: letsgo ]