dieselburb
06-02-2003, 13:49
Just got the truck back for the steering bearing fix and asked the service writer to leave a print-out of the injector balancing rates because I was hearing what sounded like a rocker arm rattle while cruising and under load. When he called and told me the truck was ready and all the balancing rates looked "fine, better than fine..." I was satisfied and picked up the truck and headed to work. When I finally looked at the readout, my number 1 was at .9mm (cubed) and no.2 was at .5mm. The rest were at .4mm and -.4mm across the board. From what I remember, the .4mm and -.4mm are the tolerance levels, correct? And if this is the case, do I just say, "Hey, change these injectors!" or what? Thanks