gavio
08-05-2005, 15:10
Sooooo, here's the deal:
A while back i posted about a problem I'd had with the recommended air filter not fitting in my van and getting scrunched, thus ruining the air seal. i could not figure out what was wrong until......
I had this loaner 6.2 pickup truck for a while and I took both air filters and put 'em next to each other and studied them......
and then I finally noticed (duh) that the air filter housing for the van is COMPLETELY different - it's so different I didn't even notice while i was busy looking for some little detail difference :rolleyes:
It's offset to the side to clear the A/C compressor and rests on a little spacer so the bottom drops differently and.......
but none of that explained my problem because it appeared that it should still take the same filter element......
until I noticed that the lid on mine appears to have been a victim of severe overtightening at some point and it actually drew the center of the lid down causing the outer lip to rise destroying its ability to seal. It may also, I suppose, have been stomped on by a wandering rhinocerous (I've heard of this happening) Mystery solved, except......
now I need a new lid and can't find one. I'm asking here because this may not be something anyone might notice in the classifieds - if anyone knows where a decent rust-free (by spoiled California standards) lid that hasn't been driven over by a tank or some such might be found, I'd appreciate the lead. i also need the mounting studs (they're longer than the ones in a truck and GM doesn't make 'em any more.)
Thanks for listening, as always......
A while back i posted about a problem I'd had with the recommended air filter not fitting in my van and getting scrunched, thus ruining the air seal. i could not figure out what was wrong until......
I had this loaner 6.2 pickup truck for a while and I took both air filters and put 'em next to each other and studied them......
and then I finally noticed (duh) that the air filter housing for the van is COMPLETELY different - it's so different I didn't even notice while i was busy looking for some little detail difference :rolleyes:
It's offset to the side to clear the A/C compressor and rests on a little spacer so the bottom drops differently and.......
but none of that explained my problem because it appeared that it should still take the same filter element......
until I noticed that the lid on mine appears to have been a victim of severe overtightening at some point and it actually drew the center of the lid down causing the outer lip to rise destroying its ability to seal. It may also, I suppose, have been stomped on by a wandering rhinocerous (I've heard of this happening) Mystery solved, except......
now I need a new lid and can't find one. I'm asking here because this may not be something anyone might notice in the classifieds - if anyone knows where a decent rust-free (by spoiled California standards) lid that hasn't been driven over by a tank or some such might be found, I'd appreciate the lead. i also need the mounting studs (they're longer than the ones in a truck and GM doesn't make 'em any more.)
Thanks for listening, as always......