no start

[Greg Marshall]

I REALLY need some help. I had to go thru the dreaded head change adn have a unrelated prolbem now. after replacing everything and checking all conections I have a no start condition. The starter spins fast enough to fire but I am not getting any glow plug light or heat at them, nor am I am I getting a ses light cnt even get it to show any codes at all.
I have no voltage at the glow plug fuse and all fuses are good. have checked all grounds even tried a new computer and a new glow plug relay with the same result. I am out of options at this point as I have no dealer in my area that will even talk about checking it, HELP!!!!! :confused:

[rameye]

I would re-check my grounds again...in particular the rear ground on the passenger side intake manifold. (I think that's the ECM ground, 2 wires one,heavy one lighter in gage) I broke mine trying to get it off..and it looks like I wasn't the first to damage it.

Check the ECM plug...is it getting juice?

Keep working backwards...it should be obvious/ easier to find. seeing that you have a whole system without power.

Is the ECM fuse getting power??

good luck!

[Barry Nave]

NO POWER AT GLOW PLUG FUSE
Do you have power to that under hood fuse block?
Power to ECM #1 and #2. Fuel relay,lights,ECT.
Have you tried running a hot wire from battery to that circut?(glow plug)

[Greg Marshall]

WEll FINALLY found all of the ground circuts and sure enough one was broken that we didnt take off must have broken it removing the head all is fine now

[Barry Nave]

Greg
Which one of the grounds was it that caused the problem?