PDA

View Full Version : Starts the stalls, dealer can figure it out



Buckle
02-09-2012, 12:42
Replaced driver few months back with relocation
Dealer said getting no fuel to injectors lift pump operating fine
Replaced injection pump with new standyne
Drove around shut off and will not start again. Died once while driving like it was starving for fuel.

I know the gurus on here will have idea to check its on way back to dealer.
Help!

Thanks in advance

racer55
02-09-2012, 14:52
Ignition switch has several contacts and any one can fail.
Often the accessories and dash work just fine but power to the ecm is lost.

Check the fuel shutoff solenoid when this occurs to see if it clicks.

JohnC
02-09-2012, 21:21
This stalling thread (http://www.thedieselpageforums.com/tdpforum/showthread.php?t=2938) will keep you busy reading for a couple of hours...

BTW, you might want to add the word "not" between "can" and "figure" in the topic line

Artworks
02-10-2012, 15:53
check ALL Grounds. behind / beside the glow controler at the back of the block. I was getting intermite stalling and no starts, pulled ecm fuse for couple seconds and reinstall & would run again. I found a poor crimped connector on this ground ( dash gauges, air bag , ecm , glow ciruit used this ground)