oil pressure light

[94bluehd]

I have a Rebco low oil pressure warning light I got about a year ago and am now wanting to put it in. I either lost the instructions or it didn't come with any. I assume one wire goes from the sending unit to the light and one goes from in ignition power source to the light? Also, where is a good place to tie it in?

[DennisG01]

The link, below, should help - I installed one about two years ago. In my case, I used the Rebco kit but found the 20psi sender that came with it was too high (depending on where the sender is tapped in). I bought a 12psi (I think) and T'd it in at the turbo feed. Works fantastic!

There's more info in here than you probably want, but there is some interesting reading.

For my sender, it only needs one wire as it grounds via screwing it in.

http://www.thedieselpageforums.com/tdpforum/showthread.php?t=31175&highlight=pressure

[94bluehd]

Great! Thank you!