LLY Injector Low Pressure Fuel Return Line

[badburban]

I just replaced one of my injectors (#2) and despite my attempts to carefully remove the lower pressure return line from the injector the fitting broke off in the injector just at the oring. I did some searching and only found one post that discusses this but it was over 2 years old, but stated that I would have to replace the whole return harness. Is this still true? I hope not, being a low pressure line and the fact that the lines look to just be pushed on, Im hoping there is a way to repair this. Thanks.

Josh

[Duramaster]

I haven't had to replace any LLY injectors lately, but last time I checked, the part is only available as an assembly. You probably have two choices here. Go to a wrecking yard and try to get the part that way or just order a new fuel return line jumper harness and just replace the broken fitting. They just use a barbed fitting that isn't too difficult to disengage. Good luck.