Oil Cooler Lines

[TCole2008]

Both my oil cooler lines are blowing oil at the crimps. Alum tube comes to front of engine then crimped on hose that goes fittings before radiator where they are crimped again to fittings. Anyone know where I can get an after market uprgraded set?
Tom
'95 6.5L TD P30 16,000 GVR 28' Trek Motorhome

[JohnC]

Click on "Advertiser's Section" at the top of this page, then click on "Lubrication Specialists".

[lfytsmith]

Do a search for Oil Cooler Line Repair, it should take you to a thread with the following part number:
The Exhaust U-Bolt style clamps are known as Air Tube Clamps in the small sizes.
The 3/4" Napa Part# is 732-1147
I used 4 of these to take care of my oil leak. If time and money are not an issue I'm sure there are better ways of stopping the leak but this was easy, cheap, and worked. Just be carefull how tight you torque them down, snug them good and repeat as necessary until leak stops. I checked my every couple of days. Hope this helps.