Lost power...

[flatbottom]

New member.....truck was running fine going down the strret. Then the little engine light came on, the sound of the truck totally changed, bamb, no power, wouldn't rev over a really weak, super sluggish 2000 rpms, and the truck would only go 15 mph. Does anyone know how to pull a code out of the truck? Does anyone have a clue what Im explaining? How do you prime the fuel after filter replacement. Please help....

[madmatt]

Have you replaced the filter yet or recently??? To prime just remove the bleeder and pump away till fuel comes out then reinsert the bleed screw.

[mr. monte]

sounds like it went into "limp mode"

you're going to have to have the codes pulled

[epa1775]

I had a similar situation happen, except not as severe. Turns out all I needed was a new fuel filter and to have the injectors flushed. Good luck. It cost me about $250 all together.

Pete