It's 10PM - I found my PMD/FSD

[ToddMeister]

Here are some pictures of the PMD/FSD assembly.

Here's the PMD:
http://www.concentric.net/~tmeister/pmd1.jpg


Here is the backside of the PMD with the transistor covers installed

http://www.concentric.net/~tmeister/pmd2.jpg


Here is the backside of the PMD with the transistor covers removed:
http://www.concentric.net/~tmeister/pmd3.jpg


Here is a close-up of a PMD transistor showing what nuts to tighten up. These can be tightened using a 1/4 inch nutdriver.
http://www.concentric.net/~tmeister/pmd4.jpg


Here's looking into the end of the electrical connector on the PMD without the calibration resistor installed:
http://www.concentric.net/~tmeister/pmd5.jpg


Here's a close-up of the calibration resistor:
http://www.concentric.net/~tmeister/calres2.jpg


Here's the other side of the calibration resistor:
http://www.concentric.net/~tmeister/calres2.jpg


Here is the calibration resistor installed into the PMD:
http://www.concentric.net/~tmeister/pmd6.jpg

[ToddMeister]

And here is a picture of the PMD mounted onto the injector pump:
http://www.concentric.net/~tmeister/pmd7.jpg

[pannhead]

i wish my camera could get close-ups like that ;)

[ToddMeister]

I took the pics using a Nikon 990 Digital Camera. I resized them to 640x480 and added comments using Paint Shop Pro version 8.1 software.

I can take a picture from 1/2 inch away with that camera!!!!

[gmctd]

Well, it's 10 am and I just read your post.

Excellent post and pics, Toddmeister!

Now, we need a link between the repair instruction post and this one - possible?

Thanks much

[moondoggie]

Good Day!

gmctd: You said,

[gmctd]

That would be a piece of work, Moondoggie, if enough folks report success.
For non-recoverable failures, the oft-rumored, much anticipated BETA replacement does hold great promise.