What tools are required to remove and replace injection lines?

[glivingstone]

Hi Guys,
Can anyone tell me what tools are required to remove and replace the injection pump lines, in particular the pump end?
I have heard a crows-foot is the anwser.

[ronniejoe]

3/4" crows foot will do the trick!

[rustyk]

A flare-nut wrench is also handy.

[NH2112]

A 3/4" Snap-on 4-way angle head wrench (http://buy1.snapon.com/catalog/item.asp?P65=&tool=all&item_ID=5235&group_ID=11569&store=snapon-store&dir=catalog) is my tool of choice. I've been able to tighten up all but the bottom 2 with the intake manifold on using one of these. What I like best about the Snap-on wrenches is Snap-on has 30- and 60-degree offsets compared to Mac, Matco, or Cornwell with their 15- and 60-degree offsets. A normal combination wrench has a 15-degree offset, so with one of the other brands you're only getting half a wrench.

[65TD]

I use a normal metric end wrench.