PDA

View Full Version : How to size a Tranny Oil Cooler



HammerWerf
06-07-2006, 09:23
Folks,
I have installed a +2 qt. oil pan on the TH400 in my 83CC. This is part of improving the cooling of the oil and engine project like so many have done, I included a temperature guage.

What I have noticed is as follows. The oil heats up slowly, in comparison to the water. The Tranny Hx is the factory in the Hot tank, thermostat is a RS 180*. I replaced the radiator last Aug, with a 4 row unit.

My family likes to go up into the local mountains for some recreation on the weekends. To get to some of these sites, the roads we take are your typical mt. roads: dirt, steep, winding, rutted. The grade
on some of these roads are up to 10%. Speed is usually around 5-10 mph. The load is fairly light stuf, a couple of bicycles, and food. Summer time temperatures can reach 100*F. I also noticed that the oil was very slow to cool, even with about a half an hour of flat to downhill driving. The temperature we are seeing is about 185*F on the road (Tank Temp), but in the Mts., the temp climbed to 210 or a bit more.

How does one size an aux Hx for this type of use. And would a fan or two be a good idea? Does the trany oil pump move much fluid at idle, and/or at speed?

I also posted this in 6.2L forum

Thanks for the help.
HammerWerf