I am going to upgrade my exhaust soon.

[woodchuck]

I have the 4 inch set and I have made sure that each pipe fits into the next pipe etc. My question is, will I be likely to need any gaskets or whetever to install the beast? The set came with the clamps and the hooks are welded on where needed (I hope). The instructions consist of 1 page with a picture and nothing else.

[Hubert]

Is it a turbo back set? If so no gasket required. At the turbo is a V band clamp and flange connection. Depending on your OE clamp you may need to replace it.

[woodchuck]

Thank you. Yes mine is a turbo back set. It was marked "FEL PRO" and was made in Canada. The quality looks good, but I have not tried to fit it into the truck yet. I am hoping for the weather to be nice enough to install it this weekend.

[sturgeon-phish]

Some jack stands will help a lot with positioning. Anticipate taking longer to adjust and tweek than to get it underthe truck. Make sure you are not hitting anything. Watch the seam where the firewall and floor meet. Take a hammer and flatten it out of the way.
Goodluck
Jim