Anyone Spindle Lift a 2wd?

[mp5medic]

Has Anyone spindle lifted a 2wd? Who makes the spindle and what size tire can you get under the truck once done? I wanted to get the front of the truck close to the same height as the rear without going ballistic with a full 6 inch lift

[DSLPOWR]

I have not personally done this, but an aquaintance of mine lifted his two wheeler like this, I believe he got a kit from Fabtech, they make quality suspension products, even for four wheel drives too. I think with a six inch you might get away with a 35x12.50 or a 315 tire, not sure though.... smile.gif

[ChaoticRacer]

With the 3.5" spindle lift, you can run 305s. With the 3.5" upper/lower a arms, and coils you can run 315s.

[DSLPOWR]

The new two wheel drives are not coil sprung, they are torsion bar just like it's four wheel drive counterpart.

[hdmax(mike)]

With the new GM HD models the lifts are the same for 4x4`s and 4x2`s. You can run 315x75x16" ( comparable to 35x12.50`s ) you will most likely have to trim a small amount on the valance. ( it is plastic, so that is an easy job.) Because the bumper hangs down as much as the 1/2 tons.

Rancho has a 4" lift, it only raises the rear about two inches. I think most other lifts are 6" or more.

[ 06-12-2002: Message edited by: hdmax(mike) ]</p>