misses when first started

[Chuck1]

I have a 1994 6.5td .When I first start it up It misses on 1 or 2 cylinders for a few seconds then levels out and runs fine.any ideas

[HowieE]

Disconnect each of the wires on the glow plugs and with an ohm meter check each plug to ground for continuity. If you find a plug that will not conduct you have found a bad plug and could be causeing the missing. Replace any bad plugs and try again in the am.

[HowieE]

Forgot to mention. If all the plugs check good replace all the wires and then one by one remove a wire and while the glow plugs are cycling check each wire you have removed for 12 volts during the cycle.
No voltage on a given wire is most likely a broken wire. Same effect as a bad plug.

[Chuck1]

All the plugs and wires are fine .Any other thoughts on what else might be wrong

[ToddMeister]

Other ideas include one or more bad injectors or cylinders low on compression...

[Chuck1]

Would injectors be the problem
just on start up .It only happens for the first 6 secounds or so .then it seems to run like a champ

[ToddMeister]

If the injector has a bad spray pattern it could cause a cold misfire due to poor atomization of fuel.