Installing new IP. Any last minute tips?

[Steve O.]

Last thing (I hope) that I need to do to the truck is swap in a new injector pump, which I plan on doing tomorrow. Its been flashing the 35 and 36 codes and a new lift pump and PMD relocation/heat sink kit didn't fix anything so its time.

I have the gasket/install kit, a new OPS and a 1 1/16" socket just for that job. I've downloaded every relevant page I can think of from the AlldataDIY.com site.

Any last minute tips, tricks, or suggestions before I dive in?

As always, thanks.

Steve

[Phil Holmen]

Make sure when you put the injector lines back on that they go in the right place... I know a guy who had a pump replaced under warranty, and had an obvious knock, the dealer told him it was a wrist pin, but we couldn't see how a wrist pin would just start after they had it, it went to two different dealers, couldn't find anything, so we started checking and they had two lines reversed....