PDA

View Full Version : cold starting



Grizz272
01-15-2003, 08:23
Well when I came out of work this morning. The temp on the rearview mirror said 3*. I waited about 9 seconds the glow wire on the dash went out so I turned the key. She started right away, she did not like it but she started. After ideling about 5 minutes I noticed a little puddle under the exhaust pipe. Would that have been condensation or unburned diesel fuel? As I said it was 3* out and the wind was blowing so I stayed in the truck. Any ideas?
I was a little concerned about cold staring. It looks like I will not have to worry.

Grizz tongue.gif

rtquig
01-15-2003, 08:53
It's condensation. If you start your truck at home, take a look and you will see the same thing, and later it will be frozen. Normal.

Grizz272
01-15-2003, 15:04
Thanks smile.gif

AKDmax
01-15-2003, 19:34
If you let it idle long enough you can create an icicle that goes from the T-pipe to the ground. Have seen that many times on the little imports when it's -40. Kinda neet...

mackin
01-17-2003, 17:36
AKDmax

Dude that's to COLD for me......Tail pipe icicles !!!!! :eek:
If mine were to form it would be black as the inside surface of my tail pipe is just a Beautiful Shade of "SOOT" !!!!!
AH DIESEL !!!!!

MAC :D :D

[ 01-17-2003: Message edited by: mackin ]</p>

AKDmax
01-17-2003, 19:41
Hey Mac,
yup, too cold for me too. I put her on the truck today. Headed for Honolulu...Going to try and have a Duramax get together once I get settled there.

conradv
01-17-2003, 19:55
So will you be "HIDmax"?