Activity Stream

De nada

THATS IT.... garcia !!

https://www.gmpartsoutlet.net/oem-parts/gm-automatic-transmission-range-selector-lever-cable-bracket-84168268 Verify the part with your VIN,...

I had the G80 in the original 10 bolt that was in my Tahoe, and I really liked it as well. I then purchased a used SF 14 bolt to replace it. It...

I've had a couple of trucks with the G80, including my current 2001 GMC 2500HD 4x4. The G80 works great. It takes a few revolutions of the slipping...

I was hoping for an answer that makes me smile!!! Thanks so much. Another guy mentioned that it could that deal. Appreciate it AGAIN!

That's what unloaded straight-pipe sounds like. The turbo won't spool/boost without a load. Do a brake stand and compare that.

And the verdict is in, that was the problem. Now shifting correctly and going thru all gears like it should. Thanks to all who have given...

A backward installed MAF would certainly cause issues, and possibly the one you're seeing. I have an aftermarket intake (AFE), and I'm not sure the...

Great pics Glad Sarah is enjoying the rig. The 599 block OMHO was/is the best block. The early 506 block with the large squirts were junk and...

This next photo is one I used in the video, showing a faint line around the #8 cylinder's deck, which indicates the close fitting cylinder sleeve -...

Ok I may have found the problem GRRRR!...It may be due to the sensor was installed opposite direction!..Yes I'm thinking so. I will test drive and...

Well the new MAF sensor didn't do the trick!...Could it be the "cold ait intake" is the problem? Too much air flow? It's an S&B setup, and...

If something is amiss with the tranny, it should set the MIL (Malfunction Indicator Lamp, AKA: SES), and P0700. If it isn't shifting correctly, or...

Thank you Maverick. You are correct I get no codes on my cheap reader, and when this happens I don't get a check engine light? I have a friend who...

Limp mode can be caused by several conditions, but the trans and throttle behavior will be similar. The SES lamp should be on, and there should be...

The latest, and thanks for the reply. I went ahead and purchased $140.00 Hitachi MAF sensor. Cleared code, installed and drove it and no issue with...

Thanks to Robyn and Jim. Got it done and is mounted in truck, truck is running, but with issues!